MILWAUKEE TOOL ACCESSORY MAKES INTIMIDATING JOBS LOOK EASY! (must have)




MILWAUKEE TOOL ACCESSORY MAKES INTIMIDATING JOBS LOOK EASY! (must have) In this video we show the …

source

Recommended For You

About the Author: VCG Construction

35 Comments

  1. Drill and tap bit combos should be avoided by anyone who gives a damn about quality work. They are the worst.

  2. The Milwaukee threading drills snap very easy. Believe it or not the Harbor Freight brand is tougher just like their 6HP shop vac beats all.😉
    Some Harbor Freight stuff surprised me.

  3. I like that. When my Surge pooped out while building a deck I was told by Milwaukee service that the surge was only meant for small fasteners like sheet metal screws. They fixed it under warranty but it sounds like he was full of crap after watching this.

  4. I always heard about how everyone despises tap and die. How they were annoying/ hard to do. I work at a place where I do it all day and just don’t see the issue people have. Throw it in drill quick in and out and it’s done

  5. When I see two carpenters using their hands to fondle each other, I tell myself I would never do that

  6. I’m a general contractor, self perform a lot of my work. There are very few tasks I am not comfortable overseeing/carrying out. But drywall is one of those that I refuse to touch. I hold my projects to a really high standard, and just know that while I can accomplish aspects of drywall well, a sub would be better suited for the job.

Comments are closed.